Posted: Mon Nov 13, 2006 1:48 am Post subject: BMP program caused to bring down the control region
I have a situation where a BMP program bring downs a IMS control region. When we investigated found that STEP has a Time parameter coded with TIME=(10,1). This program scan the database extensive. But when program abended with S322 it cause to bring down IMS control region down in production environment.
One of the solution was recommended that do not code TIME parameter on BMP step or code TIME=1440.
But when I tried to simulate same situation in Test it is not bringing down the test control region. I doubt on the solution recommended. Could someone help with this as this happened thrice.
Posted: Mon Nov 13, 2006 2:04 pm Post subject: S322 Abend
Time parameter change should work for S322 abend.....
There are two solutions i can suggest here.
1. Use TIME=NOLIMIT or 1440 , you are already tested this....
2. Check the class you are using, system group
specifies time limit for each class type.
job abend occurs if standard time limit specified in the job entry
we need to contact system people for this.
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum